Eads Instruments

Another at the shop. I received this bad ass this morning. I already have my mind set on adding my routers underneath for a full on table router setup. Doing so would make it a one stop shop for production.

Cheers!

Another successful = completed and in the books. and StewMac tools for the serious W. I also had to replace the electronics and the input jack.It turned out awesome and completely plays itself. This is better than the day it came in. 🔥❤️ With D'Addario and Co. 10 - 46's, it plays like a dream.

is

Here's something pretty stellar. This neck combo (1 of 2) will be referred to as exotic. The fretboard material is and the neck blank was . Both logs were trees that were chopped, milled out and assembled in Warrenville.

I say 1 of 2 is because I do have another piece of cherry that would go as a neck. It gets a little thin at the top but still usable. I'd have to laminate another piece to it. That's something you won't see on any large manufacturer.

Putting feelers out. Since my table router decided to send my bit to outter orbit today, wondering if anyone on here has a table router/ table shaper they're willing to part with.

TIA! \m/