Advanced Engineering & Molding Technology-Injection Molding-Mold Making

A lot of U.S. manufacturers are rethinking where their tooling and parts come from—and for good reason.

On paper, overseas production can look cheaper. But once you factor in delays, tariffs, communication issues, and quality concerns, it often costs more in the long run.

Bringing tooling and part production back to the U.S. gives you more control, faster turnaround times, and way fewer surprises. It also helps protect your IP and makes your supply chain a lot more reliable.

In today’s environment, that kind of stability matters.

If you’re in manufacturing, this is worth a read:
https://www.aemt.com/blog/news/why-domestic-tooling-and-part-production-matter-more-than-ever-for-u-s-manufacturers

That's a lot of shut-offs! The part is over 20" long. Do we have the skill to get it to fill? Check back later to see...

If you're planning on attending the show next week in Anaheim, CA stop by a say hello.

Tips and Tricks- Are weld lines affecting your parts performance or appearance? Already tried additional venting? When using a single gate try adding an overflow slug well adjecent to the weld line.