CCTT Training

Using the Fluke Networks MultiFiber Pro? Check out this short course on how to properly set reference.
https://www.easy-lms.com/multifiber-pro/course-29244

⁠

Knowing whether the problem is with the cable or connector is key to fixing a failing link quickly. Here's an example of the HDTDX screen from the Fluke Networks DSX-8000. Can you tell if the problem is with the cable or connector?

Fluke Networks CertiFiber® Pro OLTS quick start video!

Fluke Networks CertiFiber® Pro Getting Started In this video, Mike Pennacchi of Network Protocol Specialists, LLC takes you through how to setup a project, create a Loss and Length test, set a 1-Jumper re...

A common mistake when setting up a copper test is to change the Cable Type, but not change the Test Limit. Always make sure that the Test Limit matches the cable you are testing.