Microsat

Below are some photos of my another prototype device which is based on the same RF part as earlier APRS Sentry. A new unit, codename ULARI (Universal Linux Amateur/APRS Radio Interface) is a hermetic device where main board is adapted for Orange Pi Zero Linux board. On third photo you can see a nice open-source DireWolf APRS software developed by WB2OSZ, running on Linux board. In this scheme RF part of the device acts as a virtual USB sound card providing audio samples for Linux application. This should theoretically allow to use the whole device not only for APRS but also for other amateur radio purposes. If only I had more time to work all this out...

We have a firmware update for most of our devices which solves Weather Underground no data upload problem which appeared in first days of February 2017.
If you were using much older firmware versions than latest, you need to take care of changes added in later versions. Especially pay attention to correct DHCP or static IP settings (DHCP was not present in much older firmwares).
If you are using the oldest WX3in1 model (not WX3in1 Plus 1.0 or WX3in1 Mini or WX3in1 Plus 2.0), or if you are using WXEth 1.0, please contact me for firmware update. I wasn't able to make the update in reasonable time because of huge differences from lastest source code version.

Below are Configurator downloads with embedded firmware for devices:
WX3in1 Plus 2.0 installer:
http://microsat.com.pl/file_download.php?file=wx3in1plus20_configurator_v113_install.exe
WX3in1 Plus 2.0 zip:
http://microsat.com.pl/file_download.php?file=wx3in1plus20_configurator_v113.zip
WX3in1 Mini installer:
http://microsat.com.pl/file_download.php?file=wx3in1mini_configurator_v121_install.exe
WX3in1 Mini zip:
http://microsat.com.pl/file_download.php?file=wx3in1mini_configurator_v121.zip
WX3in1 Plus 1.0 installer:
http://microsat.com.pl/file_download.php?file=wx3in1plus_configurator_v147_install.exe
WX3in1 Plus 1.0 zip:
http://microsat.com.pl/file_download.php?file=wx3in1plus_configurator_v147.zip
WXEth 2.0 installer:
http://microsat.com.pl/file_download.php?file=wxeth20_configurator_v102_install.exe
WXEth 2.0 zip:
http://microsat.com.pl/file_download.php?file=wxeth20_configurator_v102.zip

microsat.com.pl

We have a new firmware update for PLXTracker TRX1W v1.03. This update changes RF chip configuration to prevent sleep mode which caused worse decoding in squelched decoding mode ("Channel busy detect" set to "analog signal level").
PLXTracker TRX1W v1.03 (http://microsat.com.pl/file_download.php?file=plxtracker_TRX1W_configurator_v103_install.exe).

microsat.com.pl