Take Place

Our last post generated a question from about our structural eaves. Thanks for the interest!

Our success with the strategy behind the soffit and eave system underscores a scenario we often looked to leverage during the design process.

How can we limit the redundancy that traditional construction methods often see?

Can one purpose built component do the job, and do it better, than numerous pieces and layers?

A structure for the roofs edge, that would typically come by way of a fascia board, clad in flashing, and later having an eave installed with a drip edge diverting water into it, was all replaced by a single purpose built component.

This approach gave us an excuse to use a material that is 6 times thicker than the gauge of a typical eave.

Better, cheaper, faster is always our aim!