BPR Mechanical

Twenty-five years of plumbing and heating in Calgary teaches you what fails again.
Real fixes look like proper supports, correct pipe sizing, and valves you can actually reach in an emergency.
We take the extra steps during installs and repairs so you’re not calling about the same drip next month.
Got a repair that keeps returning? Send a photo and what you’ve tried.

Scale does not look dramatic, but it adds up fast.

In water heaters, mineral buildup coats the heating surface, so it takes longer to recover and costs more to run. At faucets and showerheads, it narrows openings and leaves you with weaker flow and uneven spray.

If you are seeing white crust, spotty glass, or slower hot water, it is a good time to look at water treatment.

Basement owners usually find out the sump pump is failing when the pit water rises but nothing happens.
Replacement starts with sizing the pump for your pit and discharge line, then swapping the check valve and tying in the discharge properly.
After install, we test by lifting the float and pouring water into the pit to watch it start, pump out, and shut off.
Message us what you’re seeing at the sump pit, and we’ll recommend the right replacement.

Kitchen and bathroom faucets usually start dripping after the washer, cartridge, or O-rings wear down.
A plumber can pull the handle, match the right parts, and rebuild the faucet so it stops leaking.
If the body is corroded or parts are discontinued, a full faucet replacement is the clean fix.
Send a photo of your faucet and what it’s doing, and we’ll tell you the next step.

Leaks rarely start where the stain shows up.

Before: a small failure at a fitting or valve can wick into framing and drywall.

After: the damaged section is replaced, connections are re-sealed, and the line is checked under pressure so the repair holds. The goal is simple. Stop the water, then prove it is stopped.