K9 GTS Integrating Timing System

SOFTWARE UPDATE NOTICE – K9 TIMING SYSTEMS



All K9 system user ,

This notice is to advise that a software update is available for your equipment

Please check your current software installed on your timing equipment by doing the following

1. On K9 controller press Setup

2. Press option 3 ( system information)

3. Press option 1 ( revision info)

4. Option of device revisions ( depends on current version)



The current revisions are shown in this table

Device

Current Firmware Rev

Notes

K9 Controller PCB V1.0x

V0.88

May require Hardware update mods depending on current firmware installed

K9 Controller PCB V2.0x

V1.03

https://smwelectronics.com.au/k9-controller-software-release/

Type1 gates PCB V1.0x

V0.98

https://smwelectronics.com.au/type-1-gates-software-revisions/

Type1 gates PCB V2.0x

V0.02

1.2m 10 sensor RX and TX poles

Type2 gates PCB V1.0x

0.15

2 sensor gates https://smwelectronics.com.au/k9-type-2-gates-software-revisions/

Hand-switch Controller unit PCB V0.x

V0.10



Scoreboards All PCB versions

V2.03

https://smwelectronics.com.au/k9-scoreboard-software-revisions/



If you would like to update your equipment Firmware, then please complete the form in link ,

we will contact you directly to advise further details. https://smwelectronics.com.au/software-update-form/



If you no longer own the equipment or can contact the current user , please send them this notice and advise us.

Regards



Debi

K9-GTS Support

http://www.smwelectronics.com.au

K9 – Controller Software Release K9 Controller – Current Release ver 0.86 /v1.01   – update to Scoreboard firmware and gates required K9 Controller Software Release Details Ver 0.75 – initial release Ver 0.7…