Crunch Time Promotions

I hope all you derby fans and derby drivers are doing well. Here's some important show dates coming up this summer. I will have flyers and further info out shortly with payouts etc. The 2026 Rules are up on the page. Questions? Please call. There were some rule changes that were made this year that were discussed at driver's meetings during 2025 shows.

*July 10th Figure 8 Races with New Bump and Run stock compact class at the Sedgwick County Fair Cheney, KS

*July 11th Demo Derby -Weld, Bonestock Full Size, Bonestock Compact, Youth Compact and Power Wheels Sedgwick County Fair, Cheney, KS

*July 24 th (Friday) Demo Derby - Weld, Bonestock Compact, Youth Compact and Power Wheels. Pratt County Fair Pratt, KS.

*Aug 14th. Demo Derby - Weld, Bone Stock Full Size, Bonestock Compact, Youth Compact and Power Wheels. Harper County Shrine Derby Harper, KS

Noted Rule Changes..

*Weld Class-- We will be using the same rules as 716 Promotion Weld Rules. They are basically the same as last year, with a few changes. It's a good set of rules and compatible with alot of shows across the Midwest.The rules are pinned at the top of Crunch Time Promotions page.

*Bone Stock Full Size: Please refer to the rules exact details.
Regarding suspension, you will be allowed to either bolt or weld A-arms to gain height.
Front Bumpers may be seam welded, but not loaded. I highly recommend if you are using a 3"x3" square tubing or even a car bumper to round the corners or 45 of them if possible. No homemade bumpers or replicas.
You will be allowed to crease the body and body shaping from behind the rear doors back to the back bumpers only. Trunk lid can be removed or the lid must remain on hinges and tucked 50% of lid at 90°.
Regarding the cage, you will be allowed one 6" down bar in the middle of the front driver's door and in the middle of the front passenger door to sheet metal or frame.

*Bonestock Compact: please refer to the rule thread for exact details.
Front bumpers may be seam welded but not loaded. I highly recommend if you're using 3"x3" square tubing or a even a car bump or to round the corners or 45 then off if possible. No homemade bumpers or replicas.
Front struts may be welded to gain height or use spring spacers, one or the other not both ( refer to the rule).
Body creasing and body shaping will be allowed behind the rear doors to the back bumper only. Trunk lid must remain on the hinges or be completely removed, if tucked must be 50% of the lid and at 90°

See Everyone Soon,
Shane