BMC Fabrication

As promised, the mid block that took a while to get through. Its got a valve job too. The barrels got freaks, one xl and one standard and i also ported the long bull barrel but i did not groove it, that was there before it got to me. 👌

I have gotten ALL website quotes caught up and I am down to under 20 emails to reply too! The line is shrinking but that will grow when this next wave of stuff comes in.

Hope you had a spectacular Saturday!

Www.bmcfabricationservice.com

I dont have much left in me for the day, its getting HOT in the shop. Gotta dig out the fans and whatnot as summer is here!

Not going to finish this one up today, its gonna have to wait as I need to order a new ball endmill to make the last cut. (thought I had the size I need but I dont). Still gotta run the last top window and then cut the gills on both sides.

I will get back to replying to emails tomorrow night.

Hope everyone had a great weekend and lets have a spectacular week!

These were from a few weeks ago, this pile (minus the red prostock barrel) was for . Aparently this will be the last of the work from him. I was fired because my backlog is too long and I missed a cut on one body after a few years of no mistakes. 🫡

Which is great news for everyone else, just means my backlog will shrink and turnaround times will get significantly faster.

I have been replying to emails and I still got quite a list to reply too. I will continue to reply to emails for the next few evenings. If you are waiting for a reply, keep an eye on your inbox.

Have a great day!