BCS Offroad And Axle

This ‘12 2wd Tacoma wheel bearing had seen better days. So we freshened it up with a new bearing, seal, and ABS sensor.

Give us a shout for all of your upgrade, repair, and maintenance needs!

BCS Offroad and Axle
[email protected]
Facebook.com/bcsoffroadandaxle

This ‘12 JK came in for a ABS code and vibration/noise diag. After further inspection, it needed both rear axle bearings and seals, an ABS sensor, and a fresh set of spider gears.

Give us a shout for all of your upgrade, repair, and maintenance needs!


[email protected]
Facebook.com/bcsoffroadandaxle

Quick little radiator swap in this ‘97 TJ!

Give us a shout for all of your upgrade, repair, and maintenance needs!


[email protected]
Facebook.com/bcsoffroadandaxle

JT came in for a fresh set of 4.56 gears! Despite the Ohio rain, the install couldn’t have gone any smoother, and the customer was so glad to have 8th gear back at highway speeds!

Give us a shout for all of your upgrade, repair, and maintenance needs!


[email protected]
Facebook.com/bcsoffroadandaxle

This ‘16 JKU was a fun one! We did a aluminum oil cooler upgrade, brakes all the way around, installed front and rear bumpers, with a 12k winch, LED Halo headlights, and topped it off with a fresh front driveshaft courtesy of !

Give us a shout for all of your upgrade, repair, and maintenance needs!


[email protected]
Facebook.com/bcsoffroadandaxle

Today’s adventures included pads and rotors all the way around, and an upgraded aluminum oil cooler on a ‘16 JKU!

Give us a shout for all of your upgrade, repair, and maintenance needs!


[email protected]
Facebook.com/bcsoffroadandaxle

Another satisfied customer! This ‘12 JK came in needing rear pads and rotors, a rear pinion seal, and rear axle seals. After further investigation we found the passenger rear tone ring was chipped and missing a tooth, so we swapped that out while we were doing the bearings and seals.

We even do general maintenance!
This ‘88 C2500 got a fresh set of pads, rotors, and wheel bearings with seals.
What can we help you with today?

This 2020 JLU came to us with the rear end making noise. We found it to have zero pinion preload, which caused the bearings to fail and fill the diff with glitter. Remedied the problem with a fresh set of 4.56’s, and while we were in there we knocked out some fresh axle bearings and seals.

Big tires? Optimizing your gear ratio not only brings power back and optimizes shifting, but also gives you better control on the trails. Have any questions feel free to ask!
____________________________________________________